How do I adjust the stock comb? What do the 3 allen screws do?

Caution: Refer to the owners manual and make sure your firearm is unloaded and safe before performing any procedure.

ADJUSTING THE MEMORY SYSTEM

The multi-adjustable stock features a device called Memory System that can be
used to adjust the stock by modifying the drop (at comb and at heel) and the cast
(cast-on/cast-off).

The adjustable stock of your gun is preset at the factory with standard drop and
cast values. Do not loosen the center screw until instructed to do so.

ADJUSTING THE CAST
• Unscrew the two side screws of the adjustable comb using the hexagonal key
provided as indicated below.

 • Remove the adjustable comb from the stock. 



• Loosen the screws of the adjustment mechanism (arrows A and B) and
move it to the right or to the left to get the required cast as indicated below. 



• Tighten the screws of the adjustment mechanism, always using the special key
provided.

• Reassemble the adjustable comb on the stock. 
• Screw the two side screws of the adjustable comb to lock it in the required
position.

CAUTION: Only use the special key provided. Do not apply excessive force. 

ADJUSTING THE DROP

• Unscrew the two side screws of the adjustable comb as indicated below.



• Move the front and/or the rear part of the adjustable comb upwards or
downwards to obtain the required drop.

• Tighten the two side screws of the adjustable comb.

• When the drop adjustment is correct, loosen the central "memory" screw by one turn only then tighten the central "memory" screw as indicated below. 



CAUTION: Only use the special key provided. Do not apply excessive force.

NOTICE: The tightening of the central "memory" screw locks the drop position.
When you disassemble the adjustable comb from the stock, (to modify the cast
or for cleaning), it is sufficient to unscrew only the two side screws. When you
reassemble it, the "memorized" drop will be re-established.

• Check the adjustment of the cast and drop by mounting the gun.
• For a fine adjustment of the drop, loosen the central "memory" screw by one
turn and the two side screws by half-a-turn. When you move the adjustable
comb, it will "click" between the various positions by small increments.
• When the correct position is found, tighten all the three screws.

CAUTION: Only use the key provided. Do not over tighten the screws.

NOTICE: Periodically inspect your "Memory System" device. Dirt and dust can
interfere with the functioning of the adjustment mechanism. The device is made
of a high strength techno-polymer, reinforced by carbon fibers and it does not
require any lubrication. Clean the surfaces by merely wiping them down with a
clean cloth.